# how to open a 3 digit combination lock box

This can be deduced only by checking the range of motion of the disk that gets stuck. Depending on the lock, there could be several different ways to change the combination. Insert the key and work it from side to side while compressing the lock. Since requirements depend on the lock, you may need to try both with the clasp open and closed. Leaving digit wheels on old combination, insert attached combination changing tool and press it as far as it will go.

turn the combination tool 180 degrees until it is aiming at the shackle.

Open Lock and expose shackle hole. You may have to turn the tool or paper clip 90 degrees or keep the tool pushed in while changing the combination.Slowly reset each dial to the new number. Begin by opening your Combination Lock Box. Spray WD-40. This range of motion becomes smaller in the correct number. Give it a couple more taps with the hammer. Descott has a Bachelor of Arts in social sciences. They did not seem to have key locks so I took a combination lock to simply slow down any attempt to access my locker. However the next disk seems to turn freely.As shown in figure 3, the only candidates that need examination are 2 and 7 as they are the lowest candidates from each two close candidates (the set containing 2 and 4 is reduced to 2, and the one containing 7 and 9 is thus reduced to 7). As you apply a force as if you are trying to open the lock, turn the disk that is the closest to the opening part until you hear a clicking sound. Luggage locks either come with a preset combination that is provided by the manufacturer or are set to a neutral combination like 0-0-0. To open a new lock box for the first time: Move all 3 digits to 0-0-0. Covering subjects such as parenting and travel, she has been published in "Lonely Planet" and "Get Born" magazine. Then, check what number you're at, add 5 to that number, and write it down. here are some examples with step by step instructions on how this could be implemented in two sample locks.Here are the steps I used to unlock my Nutramino 3 digit lock:Start with the rotating disk that is the closest to the shackle.If you pull the shackle and try to rotate the disk it gets stuck. Once you change the combination from 000 to your new number, you will be the only one who can access the box! Then, write down whatever number you're at.

Depending on the lock, there could be several different ways to change the combination.

When all three dials are set, return the tool to the original position or take it out of the reset hole. Test to see if the new combination works.Open the lock using the previous combination if attempting to reset the combination with the clasp closed doesn't work.Open the clasp until it clicks or stops, either 90 degrees or 180 degrees.
LPS or Liquid Wrench down the shaft and up into the keyhole. If there is one, set the lock to its current combination.Insert either the manufacturer-provided reset tool or the end of an unfolded paper clip. Important: When changing to new combination, dial setting must remain on old combination! The dial moves tumblers inside the locking mechanism to align them in the correct pattern to open the safe. While I do not keep any valuables inside the locker anymore I just use the lock because it will make the experience of opening my locker more painful and risky. To open an existing lock box: Move all 3 digits to the current opening combination. Its very important that you remember your new 3 digit combination! After testing the new combination, spin all three dials to secure the lock.Reset the combination while the lock is closed if there is no reset hole.Enter the lock's current combination and push in on the clasp.Keep the clasp pushed in and enter the new combination on the dials. If your lock is attached to something, you will need to call a … There is only one number where you will hear/feel the clicking. Knowing how to open your own locks can sometimes be far more useful than enabling you to see them as a tool for slowing down thieves by a couple more minutes.

Luggage locks either come with a preset combination that is provided by the manufacturer or are set to a neutral combination like 0-0-0. Set the combination dials on the product to "000" if you have not yet set a personal combination code. I am also relying on the fact that there is a constant flow in the locker room and a thief might be afraid that the owner can show up at any moment.Oh!